Injection Molding Companies

/in , , , , , , , , , , , , , , , /by

Injection Molding Companies

These are some of the top companies in the United States in the injection molding field. If you are looking for a great company with great reputations, check out these companies.

MOCAP, Inc, located in St. Louis, MO. They are a full service company; they are a manufacturer of standard and custom injection molding designs. They use all grades of plastic and they do a lot of volume and can handle as little or as much volume as needed.

Precision Tool & Die located in Derry, New Hampshire. They are an all purpose company, they provide custom manufacturing, service and a general manufacturer. They provide on site molding with perfect injection molds, they also do insert molds, transfer molds and they also do complete designs.

World Class Plastics located in Russell Point, Ohio, this company is also a custom manufacturer, a service and a manufacture company. Their company profile says they are QS9000 registered, they do custom thermoplastic injections, and they fabricate molds and tool design.

The G&F Industries located in Sturbridge, MA, they are a service and manufacture company. They are listed as an ISO 9000 certified company; they have a great reputation in the fabrication of injection Plastic Molding and plastic fabrications that use the injection molding process. They also use a robotic system and a real time production team.

Do you know any other injection molding companies that deserve to be mentioned here?

Injection Molding Glossary

/in , , , , , , , , , , , , , , , /by

Injection Molding Glossary

Injection Molding: this is a technique used to fabricate parts made from thermoplastic materials.

Thermoplastic materials: are materials made out of plastic that are able to melt into a liquid when heated at a high enough heat and when it freezes it will be in a glassy state when it is cooled.

Polystyrene is a polymer that is a liquid hydrocarbon that is commercially made from petroleum.

Polypropylene is a very hard plastic that is used for many different uses such as food packaging, reusable containers and textiles. It is a very durable and rugged unusually.

Resin is comes from many plants especially from the Coniferous tree that is used for its chemicals. You can use resin for adhesives and incense and some perfumes.

Solidify is to become hard or firm.

Pellet is a small compressed piece of material or a substance.

Nylon is a chemically resistant, it is also heat resistant, but it is tough and very flexible.

Injection Molding Questions and Answers

/in , , , , , , , , , , , , , , , /by

Here are some frequently asked questions when there are problems in the process of injection molding, here some of the most popular ones and their solutions.

What happens when the molds are brittle and delaminate? The cause may be an improper injection screw. The screw that is used for molding at a low-pressure ratio fro the amount of resin being used; causes the plastic’s molecules to form incorrectly. Basically, a weak molecular structure can cause brittle parts. When this happens de lamination can occur as well. The result will be a to take a pressure reading and record the ratio. This should be performed once every six months.

Another problem may be discoloration; the possible cause for this may be excessive dwell time or what they call residence time. When a part has been discolored or changed the problem is usually found in the residence time. The material stays in the barrel too long, the base will become discolored. What can be done is the heat sensitive materials have to be set at a certain ration. After every injection shot clean out the barrel.

Discoloration may also be caused by an improper plastic mold temp. The hotter the mold is it will keep the material melted for a longer period of time. The temp of the mold should be adjusted to the supplier’s specs on material and cycle times.