Process of Injection Molding
The process of injection molding process is best explained as heating up a type of plastic and under a forced type or pressure is poured into a predesigned mold, after the hot liquid is poured into the mold the mold is clamped shut to prevent any air from getting in. After the initial work is done, the mold hardens and takes the shape of the mold.
Then the next step in the process is when the resin (hard plastic) which is now in the shape of a small pellets are poured into the feed hopper, the hopper is a large open bottomed contained and what it does is that is filters the pellets into the screw.
As the screws turn the resin pellets are moved into the screw and then they go through a very intense pressure. Then friction is created and when that happens heat is generated to melt the pellets. There are heaters on both sides of the screws and there is temperature control during the melting process.
The oil gets pumped from the tank to the injection molded parts that run along the tie bar equipment, then that’s when the liquid plastic gets injected into the mold. Then the water-cooling technique is applied in assist in cooling off the mold. The process is complete when the mold is pulled from the pre-designed mold.