Posts

Injection Molding Process

/in , , , , , , , , , , , , /by

Process of Injection Molding

The process of injection molding process is best explained as heating up a type of plastic and under a forced type or pressure is poured into a predesigned mold, after the hot liquid is poured into the mold the mold is clamped shut to prevent any air from getting in. After the initial work is done, the mold hardens and takes the shape of the mold.

Then the next step in the process is when the resin (hard plastic) which is now in the shape of a small pellets are poured into the feed hopper, the hopper is a large open bottomed contained and what it does is that is filters the pellets into the screw.

As the screws turn the resin pellets are moved into the screw and then they go through a very intense pressure. Then friction is created and when that happens heat is generated to melt the pellets. There are heaters on both sides of the screws and there is temperature control during the melting process.

The oil gets pumped from the tank to the injection molded parts that run along the tie bar equipment, then that’s when the liquid plastic gets injected into the mold. Then the water-cooling technique is applied in assist in cooling off the mold. The process is complete when the mold is pulled from the pre-designed mold.

Injection Molding Machines

/in , , , , , , , , , , , , , , , , /by

Injection Molding Machines

One type of injection molding machine is the Milacron LIM, Liquid Injection Molding; there are many benefits in having this machine over the traditional LIM. This machine has its own controls and especially made soft ware for this product only. It has a low pressure set up for injection setup and it has a closed loop control.

Unlike the traditional LIM this machine has an increased power ejector force, so it can inject the mold quicker. It has a standard injection screw, a cooling plate on both sides, eight new pneumatic valves, and two heat zones on each paten, a 3-stage air ejector. The improvements from the standard LIM also include a revised rear seal on the injector screw and also a revised seal that is on the nozzle.

These machines have a thermo set process that uses a silicone rubber material that is used to be injected into the heat plastic molds. The best part about these Milacron machines is that no other machine can use their software is designed just for their machines and no one else’s. The Milacron also has a complete design line of Fluid Auto meter mixers.

Milacron is one of the best in the business of injection molding and if your company needs to replace a machine, consider this one, it is one of the best.